|
This Kit Includes:
Y-link kit: 4 7/8"-18 Chevy tie rod ends
(x1 es2033L, x1 es2027L, x2 es2234R)
or
Crossover kit: 4 7/8"-18 Chevy tie rod ends
(x1 es2034L, x1 es2027L, x2 es2234R)
plus
-
4 Tube adapters for rod-ends machined from 1020 DOM steel
-
Two 1.5"OD .250 wall tubes for tie rod and drag-link up to 58" long
-
4 Jam nuts (two left hand and two right hand thread)
-
TIG welding available
Note: the es2027L is a drag link end and has a different taper than the other Tie Rod ends. It is intended for mounting on a pitman arm but will require further reaming of any stock pitman arm to fit. The reamer used for the standard TRE's (1.5 inches/foot) will work to ream out the pitman arm but will require a deeper reaming.
All tie rod and drag link lengths are to be measured eye-to-eye. If you are unsure of this length please select 'No welding' and you will receive 58" long tubes. Ballistic Fabrication is not responsible for inaccurate measurements on the part of the customer and corrections made to the linkages will be subject to additional charges including shipping. | 
