Weld-on 9" axle flanges for housings with 3" or 3.5" OD tubes are the best way to set up your fabricated housing for semi-float axles. These bearing ends are machined to slip over the outer-diameter of the tube, vs a butt-welded alternative. Machined from a solid billet of 1018 cold rolled steel and drilled with three extra bolt holes, these ends are the ultimate in strength and reliability.

 

Add a set of shims and backing plate retainers to be able to utilize all seven bolt holes for maxinum strength. For use with Timken "Kit 20" bearing kits.